You can also use the digipeater in store-and-forward mode by setting a long TX Delay (the number is in seconds). Collisions, fading, and other effects will often cause your packets to not be digipeated, and you’ll need to repeat your transmission until it is digipeated by Greencube. Note that you’ll want to confirm that Greencube has heard and digipeated each of your transmissions. When you are done, you can right-click on the last packet in the exchange or on the station’s callsign that you have worked in one of the right windows to log the contact. Next, use the INFO button to send your callsign and grid square and then the RRR and 73 buttons to complete your contact. You can begin to make a contact by either clicking on another station’s CQ to load the station’s callsign or by just calling CQ yourself. You’ll want to set the Tx delay for 0 – 2 seconds to give your preamp time to recover from transmitting before you receive your digipeater packets back from Greencube. A low-noise preamp at the antenna is recommended.A computer running modem software and a Greencube Terminal Program.Software to control the Transceiver to correct for Doppler shift and provide antenna tracking control or pointing information.A 70cm SSB/FM capable Transceiver with a soundcard interface and at least 25 watts of output at the antenna.A directional antenna with at least 12 dBi gain.Greencube (IO-117) requires the following for successful contacts via its digipeater: Operating with Greencube – What’s Required We’ll cover Greencube (IO-117) setup in detail in this article. If you already have a computer-controlled satellite ground station that works on 70cm, you may already have most of what is needed. ![]() Putting together a station and the necessary software to use Greencube is not difficult. This satellite can provide DX contacts covering a wide area around an Amateur Radio satellite ground station. Greencube (IO-117) is a Medium Earth Orbit (MEO) satellite that carries a 70cm digipeater. Remember, you'll need to pay $100 (about £69, AU$140) to enroll.Typical Greencube Pass Providing DX Possibilities Click the 'Start Your Enrollment' to begin and then follow the instructions. You'll need an Apple ID, and provide your basic personal information. If you’re not currently enrolled, then go to the Apple Developer Program enrollment webpage, which will show you everything you need to sign up. To do that, you need to be enrolled in the Apple Developer Program. Once you've downloaded macOS 11 Big Sur, you might want to play with the more cutting edge developments in the OS that aren't available to the public yet. ![]() How to enroll in the Apple Developer Program For information on how to do this, head over to our ultimate guide to backing up your Mac. Whenever you upgrade your operating system we highly recommend backing up the files on your Mac, so if anything goes wrong you can quickly restore your machine to its previous working order.īefore you download and install macOS 11 Big Sur, make sure your Mac is backed up. ![]() (Image credit: Apple) Back up your Mac before upgrading to macOS 11 Big Sur
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |